Home Network – 2026 Edition Part 2
Most 2026 changes may be found in Home Network – 2026 Edition. This update only covers a couple minor changes made since then.
I thought I was done with network updates in 2026, but squeezed a few more things in to round out the year. Most of these changes were cosmetic, but I did install one more piece of network equipment.
After completing the last round of upgrades, I found that I was lacking one 2.5G port to handle the planned upgrade of a WiFi access point from a WiFi 5 model to a WiFi 7 one. My 48 port switch has been a workhorse for years and had no issues. However, all of its ports were 1G ones except for a couple of 10G ports for connecting to the network backbone. Also, due to the recent addition of a 16 port PoE switch, I was using less than half of the switch’s 48 ports with no idea how all those excess ports would ever be used. Therefore, I purchased a 24 port switch that provided 8 2.5G ports and removed the 48 port switch to be sold to help offset the cost of the new hardware. The new switch also contained two 10G ports which were combined to provide a 20G connection to the recently added aggregation switch.
On the cosmetic side, I moved all the coax connections out of the keystone panels at the top of the rack and moved them to the side. I also replaced many of the Ethernet cables running from the keystone panels to the switches with thin, short ones. These changes made it so every possible port on my switches had corresponding spaces in the keystone panels while still allowing for eight keystone spaces to handle (now unused but still wired) phone lines with a few spaces left for future expansion. The smaller, thinner cables give the rack a cleaner look, and work well with the lighted ports on the new switch.
Even though I ultimately reduced the overall number of switch ports available, I have enough capacity to handle the few remaining items I plan to add at some point along with some excess capacity for things that are not currently planned or even imagined. The next project on the network side will probably be to improve cable management by installing cable trays in the ceiling. Today, the cords run along the ceiling of the basement held up by zip ties, staples, and random pieces of wood attached to rafters, water and gas lines. This is not only for cosmetic reasons as it should allow for easier management of these cables. I also plan to replace some of the existing runs using Cat5e cables with Cat6 ones. This should hopefully provide more speed to the few 2.5G devices in the house currently running over Cat5e.
Of course, I reserve the right to change my mind, but at least for now, (and barring any of my existing equipment becoming obsolete and no longer supported), I think this version of the core network can be called feature complete and will not see any major changes for years to come.